Total Building Solutions Under One Roof
Pre-Engineered Buildings concept specially known for economical design and compactness because they yield to strength and stability with minimal thickness. These are the structures basically produced at the factory with high tensile steel material by collecting complete information of the shed/building (viz; Length, Width, Height etc,). The entire design of column, rafters and other accessories is based on International structural standards and involve high technical welding and quality production. The entire requirement is produced on modular basis in house and shall be assembled at the customer's site with minimum time period and least cumbersome.
Primary Structural Members
Primary members consist of columns, rafters, beams etc. These are fabricated from high. Strength 354mpa Plates. Plates are cut to size and shape. Built up sections are made from these plates in Automatic Beam welding Line by submerged Arc Welding.
The most common primary framing systems are shown below. All are shown symmetrical about the ridge line. Framing systems unsymetrical about the ridge line and Multispan Framing Systems with unequal width modules are possible but may require more engineering time and possibly longer deliveries. Practically any frame geometry is possible. Consult a Artifex Infra representative for your specific requirements.
Secondary Structural Members
PURLINS: Secondary Members used in a PEB include purlins,side runners, eave struts, fascia channels ,door posts window posts, rafter stays, column stays, base angles, and other Miscellaneous structural parts.Purlins and grits are cold roll formed light gauge "Z" sections varying in depth from 180 to 300 mm and in thickness from 1.5 to 2.5 mm as per design requirement. The basic structural shape used by Artifex Infra, is given below.